Iei-integration ECN-360A-D2550 Manual de usuario descargar pdf (Pagina 116)

ECN-360A-D2550 Embedded System

Page 105

Step 1: Hardware and BIOS setup. Refer to Section C.2.1.

Step 2: Install Linux operating system. Make sure to install GRUB (v0.97 or earlier)

MBR type and Ext3 partition type. Leave enough space on the hard drive to

create the recover partition later.

NOTE:

If the Linux OS is not installed with GRUB (v0.97 or earlier) and Ext3,

the Symantec Ghost may not function properly.

While installing Linux OS, please create two partitions:

 Partition 1: /

 Partition 2: SWAP

NOTE:

Please reserve enough space for partition 3 for saving recovery

images.

Figure C-29: Partitions for Linux

Step 3: Create a recovery partition. Insert the recovery CD into the optical disk drive.

Follow Step 1 ~ Step 3 described in Section C.2.2. Then type the following

commands (marked in red) to create a partition for recovery images.

system32>diskpart

DISKPART>list vol

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 140 141

Sin comentarios

Iei-integration ECN-360A-D2550 Manual de usuario Pagina 116