Iei-integration ACT-457A Manual de usuario descargar pdf (Pagina 34)

ACT-457A Panel PC

Page 26

Step 1: Locate the DB-9 connector. The location of the DB-9 connector is shown in

Chapter 2.

Step 2: Insert the serial connector. Insert the DB-9 connector of a serial device into

the DB-9 connector on the bottom panel. See Figure 2-15.

Figure 2-15: Serial Device Connector

Step 3: Secure the connector. Secure the serial device connector to the external

interface by tightening the two retention screws on either side of the connector.

Step 0:

2.8.3 USB Device Connection

There are four external USB 2.0 connectors. All connectors are perpendicular to the

ACT-457A. To connect a USB 2.0 or USB 1.1 device, please follow the instructions below.

Step 1: Located the USB connectors. The locations of the USB connectors are shown

in Chapter 2.

Step 2: Align the connectors. Align the USB device connector with one of the

connectors on the bottom panel. See Figure 2-16.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 66 67

Sin comentarios

Iei-integration ACT-457A Manual de usuario Pagina 34