Iei-integration AFL-15i-HM55 v1.20 Manual de usuario descargar pdf (Pagina 55)

AFL-HM55 Series Panel PC

Page 44

3.10.3 Arm Mounting

The AFL-HM55 Series is VESA (Video Electronics Standards Association) compliant and

can be mounted on an arm with a 75mm or 100mm interface pad. To mount the

AFL-HM55 Series on an arm, please follow the steps below.

Step 1: The arm is a separately purchased item. Please correctly mount the arm onto

the surface it uses as a base. To do this, refer to the installation documentation

that came with the mounting arm.

NOTE:

When purchasing the arm please ensure that it is VESA compliant and that

the arm has a 100 mm interface pad. If the mounting arm is not VESA

compliant it cannot be used to support the AFL-HM55 Series flat panel PC.

Step 2: Once the mounting arm has been firmly attached to the surface, lift the flat panel

PC onto the interface pad of the mounting arm.

Step 3: Align the retention screw holes on the mounting arm interface with those in the

flat panel PC. The AFL-HM55 Series arm mount retention screw holes are

shown in

Figure 3-23.

Figure 3-23: Arm Mounting Retention Screw Holes

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 142 143

Sin comentarios

Iei-integration AFL-15i-HM55 v1.20 Manual de usuario Pagina 55