Iei-integration AFL-15i-HM55 v2.00 Manual de usuario descargar pdf (Pagina 37)

AFL-HM55 Series Panel PC

Page 26

3.9 Jumper Settings

NOTE:

A jumper is a metal bridge used to close an

electrical circuit. It consists of two or three metal

pins and a small metal clip (often protected by a

plastic cover) that slides over the pins to connect

them. To CLOSE/SHORT a jumper means

connecting the pins of the jumper with the plastic

clip and to OPEN a jumper means removing the

plastic clip from a jumper.

The following jumpers can be found on the motherboard installed in the AFL-HM55 Series.

Before the AFL-HM55 Series is installed, the jumpers must be set in accordance with the

desired configuration. The jumpers on the AFL-HM55 Series motherboard are listed in

Table 3-1.

Description Label Type

Clear CMOS setting J_CMOS1 3-pin header

COM1 Pin 9 setting JP7, JP8 6-pin header

COM3 TX function select JP9 6-pin header

COM3 RS-232/422/485 JP10 12-pin header

COM3 RS function select JP11 8-pin header

ME Debug Mode JP12 2-pin header

iTPM setting J_ITPM1 3-pin header

ME RTC select ME_RTC1 3-pin header

SPI setting J_SPI1 3-pin header

Table 3-1: Jumpers

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 139 140

Sin comentarios

Iei-integration AFL-15i-HM55 v2.00 Manual de usuario Pagina 37