Iei-integration AFL-ххA-N26 Manual de usuario descargar pdf (Pagina 34)

AFL-xxA-N26 Series Panel PC

Page 34

 Anti-static Discharge: If a user open the rear panel of the flat panel PC, to

configure the jumpers or plug in added peripheral devices, ground themselves

first and wear and anti-static wristband.

3.3 Installation and Configuration Steps

The following installation steps must be followed.

Step 1: Unpack the flat panel PC

Step 2: Install a mSATA SSD card

Step 3: Install a HDD (AFL-12A-N26 only)

Step 4: Configure the system

Step 5: Connect peripheral devices to the bottom panel of the flat panel PC

Step 6: Mount the flat panel PC Step 0:

3.4 Opening the System

WARNING:

Over-tightening back cover screws will crack the plastic frame.

Maximum torque for cover screws is 5 kg-cm (0.36 lb-ft/0.49 Nm).

To access the AFL-xxA-N26 internally the back cover and the internal aluminum cover

must be removed. To remove the covers, please follow the steps below.

Step 1: Remove the retention screws (

Figure 3-1) and lift the back cover off the flat

panel PC.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 151 152

Sin comentarios

Iei-integration AFL-ххA-N26 Manual de usuario Pagina 34