Iei-integration AFL-F08A v1.01 Manual de usuario descargar pdf (Pagina 31)

AFL-F08A Panel PC

Page 19

3.7 Jumper Settings

NOTE:

A jumper is a metal bridge used to close

an electrical circuit. It consists of two or

three metal pins and a small metal clip

(often protected by a plastic cover) that

slides over the pins to connect them. To

CLOSE/SHORT a jumper means

connecting the pins of the jumper with

the plastic clip and to OPEN a jumper means removing the plastic clip

from a jumper.

The following jumpers and switches can be changed after removing the rear cover.

Description Label Type

Clear CMOS J_COMS1 2-pin header

COM1 Pin 9 setting JP8 10-pin header

COM3 Pin 9 setting JP10 6-pin header

COM3 RX RS-232/422/485 select JP9 8-pin header

COM3 TX RS-422/485 select JP11 6-pin header

COM3 RS-232/422/485 select JP6 12-pin header

Table 3-1: Jumpers

3.7.1 Access the Jumpers

To access the jumpers, remove the back cover. To remove the back cover, please refer to

Section

3.4.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 141 142

Sin comentarios

Iei-integration AFL-F08A v1.01 Manual de usuario Pagina 31