Iei-integration AFL-F08A v2.40 Manual de usuario descargar pdf (Pagina 37)

AFL-F08A-N270 Panel PC

Page 22

Figure 3-7: AT/ATX Power Selection Switch

3.7.4 Clear CMOS Jumper

Jumper Label: J_CMOS1

Jumper Type:

2-pin header

Jumper Settings:

See

77Table 3-3

Jumper Location:

See

77Figure 3-8

If the AFL-F08A-N270 fails to boot due to improper BIOS settings, the clear CMOS jumper

clears the CMOS data and resets the system BIOS information. To do this, use the jumper

cap to close the pins for a few seconds then remove the jumper clip.

If the “CMOS Settings Wrong” message is displayed during the boot up process, the fault

may be corrected by pressing the F1 to enter the CMOS Setup menu. Do one of the

following:

 Enter the correct CMOS setting

 Load Optimal Defaults

 Load Failsafe Defaults.

After having done one of the above, save the changes and exit the CMOS Setup menu.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 178 179

Sin comentarios

Iei-integration AFL-F08A v2.40 Manual de usuario Pagina 37