Iei-integration AFL2-12A-HM65 v1.00 Manual de usuario descargar pdf (Pagina 68)

AFL2-12A-HM65 Series Panel PC

Page 68

Step 8: Install the new DDR3 memory module by pushing it into the socket at an angle

(Figure 5-3).

Step 9: Gently pull the spri

ng retainer clips of the SO-DIMM socket out and push the

rear of the DDR memory module down (Figure 5-3).

Step 10: Release the spring retainer clips on the SO-DIMM socket. They clip into place

and secure the DDR memory module in the socket.

Figure 5-3: DDR SO-DIMM Module Installation

Step 11: Replace the internal aluminum cover and secure it to the chassis using six (6)

retention screws.

Step 12: Replace the back cover and secure it using nine (9) previously removed

retention screws. Step 0:

5.5.2 WLAN Card Replacement

The AFL2-12A-HM65 has one WLAN card slot. To replace the WLAN card, follow the

instructions below.

Step 1: Follow all anti-static procedures. See Section 5.2.

Step 2: T

urn off the power. See Section 5.3.

Step 3: Remove the

back cover. See Section 5.4.1.

Step 4: Remove the i

nternal aluminum back cover. See Section 5.4.2.

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 185 186

Sin comentarios

Iei-integration AFL2-12A-HM65 v1.00 Manual de usuario Pagina 68