Iei-integration AFL2-17A-H61 v1.02 Manual de usuario Pagina 120

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 266
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 119
AFL2-17A/AB-H61
Page 101
6.3 Jumper Settings
NOTE:
A jumper is a metal bridge used to close
an electrical circuit. It consists of two or
three metal pins and a small metal clip
(often protected by a plastic cover) that
slides over the pins to connect them. To
CLOSE/SHORT a jumper means
connecting the pins of the jumper with
the plastic clip and to OPEN a jumper means removing the plastic clip
from a jumper.
The following jumpers can be found on the motherboard installed in the
AFL2-17A/AB-H61. Before the AFL2-17A/AB-H61 is installed, the jumpers must be set in
accordance with the desired configuration. The jumpers on the AFL2-17A/AB-H61
motherboard are listed in Table 6-31.
Description Label Type
LVDS voltage selection DJ2 3-pin header
LCD panel selection DJ3, DJ4, DJ5, DJ6 2-pin header
Table 6-31: Jumpers
6.3.1 LVDS Voltage Selection
Jumper Label: DJ2
Jumper Type:
3-pin header
Jumper Settings: See Table 6-32
Jumper Location: See Figure 6-35
Use the LVDS voltage selection jumper to select the voltage of the LVDS connector.
Vista de pagina 119
1 2 ... 115 116 117 118 119 120 121 122 123 124 125 ... 265 266

Comentarios a estos manuales

Sin comentarios