Iei-integration AFL2-17A-H61 v1.11 Manual de usuario Pagina 84

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 275
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 83
AFL2-17A/AB-H61
Page 65
NOTE:
When purchasing the arm please ensure that it is VESA compliant and that
the arm has a 100mm x 100mm interface pad. If the mounting arm is not
VESA compliant it cannot be used to support the AFL2-17A/AB-H61 flat
bezel panel PC.
Step 2: Once the mounting arm has been firmly attached to the surface, lift the flat bezel
panel PC onto the interface pad of the mounting arm.
Step 3: Align the retention screw holes on the mounting arm interface with those in the
flat bezel panel PC (Figure 5-21).
Figure 5-21: Arm Mounting Retention Screw Holes
Step 4: Secure the flat bezel panel PC to the interface pad by inserting four retention
screws through the bottom of the mounting arm interface pad and into the flat
bezel panel PC. Step 0:
5.14 External Peripheral Device Connection
The following external peripheral devices can be connected to the external peripheral
interface connectors.
Vista de pagina 83
1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 274 275

Comentarios a estos manuales

Sin comentarios