Iei-integration AFL2-17A-H61 v1.23 Manual de usuario descargar pdf (Pagina 132)

AFL2-17A/AB-H61

Page 112

6.3 Jumper Settings

NOTE:

A jumper is a metal bridge used to close

an electrical circuit. It consists of two or

three metal pins and a small metal clip

(often protected by a plastic cover) that

slides over the pins to connect them. To

CLOSE/SHORT a jumper means

connecting the pins of the jumper with

the plastic clip and to OPEN a jumper means removing the plastic clip

from a jumper.

The following jumpers can be found on the motherboard installed in the

AFL2-17A/AB-H61. Before the AFL2-17A/AB-H61 is installed, the jumpers must be set in

accordance with the desired configuration. The jumpers on the AFL2-17A/AB-H61

motherboard are listed in Table 6-31.

Description Label Type

LVDS voltage selection DJ2 3-pin header

LCD panel selection DJ3, DJ4, DJ5, DJ6 2-pin header

Table 6-31: Jumpers

6.3.1 LVDS Voltage Selection

Jumper Label: DJ2

Jumper Type:

3-pin header

Jumper Settings: See Table 6-32

Jumper Location: See Figure 6-35

Use the LVDS voltage selection jumper to select the voltage of the LVDS connector.

1 2 ... 127 128 129 130 131 132 133 134 135 136 137 ... 277 278

Sin comentarios

Iei-integration AFL2-17A-H61 v1.23 Manual de usuario Pagina 132