Iei-integration AFL2-W10A-N28 Manual de usuario descargar pdf (Pagina 37)

AFL2-W10A-N28 Panel PC

Page 19

 Anti-static Discharge: If a user open the rear panel of the flat bezel panel PC,

to configure the jumpers or plug in added peripheral devices, ground

themselves first and wear an anti-static wristband.\

3.3 Installation and Configuration Steps

The following installation steps must be followed.

Step 1: Unpack the flat bezel panel PC.

Step 2: Install the HDD.

Step 3: Install the RFID reader. (optional)

Step 4: Configure the system.

Step 5: Connect peripheral devices to the flat bezel panel PC.

Step 6: Mount the flat bezel panel PC. Step 0:

3.4 HDD Installation

WARNING:

Over-tightening back cover screws will crack the plastic frame.

Maximum torque for cover screws is 5 kg-cm (0.36 lb-ft/0.49 Nm).

To install the HDD into the AFL2-W10A-N28, please follow the steps below:

Step 1: Remove two (2) retention screws from the HDD cover (

8Figure 3-1).

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 205 206

Sin comentarios

Iei-integration AFL2-W10A-N28 Manual de usuario Pagina 37