Iei-integration AFL2-W21-H61 Manual de usuario descargar pdf (Pagina 60)

AFL2-W21A/AB-H61

Page 41

 Anti-static Discharge: If a user open the rear panel of the flat bezel panel PC,

to configure the jumpers or plug in added peripheral devices, ground

themselves first and wear and anti-static wristband.

4.3 Installation and Configuration Steps

The following installation steps must be followed.

Step 1: Unpack the flat bezel panel PC.

Step 2: Install the HDD.

Step 3: Install the K-type temperature sensor.

Step 4: Install the RFID reader (optional).

Step 5: Install the CD-ROM (optional).

Step 6: Configure the system.

Step 7: Connect peripheral devices to the flat bezel panel PC.

Step 8: Mount the flat bezel panel PC. Step 0:

4.4 HDD Ins tallation

WARNING:

Over-tightening back cover screws will crack the pla

stic frame.

Maximum torque for cover screws is 5 kg-cm (0.36 lb-ft/0.49 Nm).

To install the HDD into the AFL2-W21A/AB-H61, please follow the steps below:

Step 1: Remove two (2) retention screws from the HDD cover (Figure 4-1).

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 261 262

Sin comentarios

Iei-integration AFL2-W21-H61 Manual de usuario Pagina 60