Iei-integration IMB-C2160 Manual de usuario descargar pdf (Pagina 72)

IMB-C2160 Micro-ATX Motherboard

Page 57

4.4 Jumper Settings

NOTE:

A jumper is a metal bridge used to close an

electrical circuit. It consists of two or three metal

pins and a small metal clip (often protected by a

plastic cover) that slides over the pins to connect

them. To CLOSE/SHORT a jumper means

connecting the pins of the jumper with the plastic

clip and to OPEN a jumper means removing the

plastic clip from a jumper.

Figure 4-8: Jumper Locations

The jumpers on the IMB-C2160 must be set in accordance with the desired configuration

before installation. The jumpers on the IMB-C2160 are listed in Table 4-1.

Des cription Label Type

AT/ATX power select JATX_AT1 2-pin header

Clear CMOS J_CMOS2 3-pin header

WOL Mode select WOL_SEL1 3-pin header

Table 4-1: Jumpers

4.4.1 AT/ATX P o w e r Select Jumper

Jumper Label: J ATX_AT1

Jumper Type:

2-pin header

Jumper Settings: See Table 4-2

Jumper Location: See Figure 4-9

The AT/ATX power select jumper specifies the systems power mode as AT or ATX.

Setting Description

Closed ATX Mode (Default)

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 204 205

Sin comentarios

Iei-integration IMB-C2160 Manual de usuario Pagina 72