
IMB-H610 Micro-ATX Motherboard
The USB power select jumpers allow the user to select the USB power setting.
Setting Description
Short 1-2 +5V
Short 2-3 +5V_Dual (Default)
Table 4-4: USB Power Select Jumper Settings
Figure 4-11: USB Power Select Jumpers Location
4.5 Internal Peripheral Device Connections
This section outlines the installation of peripheral devices to the onboard connectors.
4.5.1 SATA Drive Connection
The IMB-H610 is shipped with four SATA drive cables. To connect the SATA drives to the
connectors, please follow the steps below.
Step 1: Locate the connectors. The locations of the SATA drive connectors are shown
in Chapter 3.
Step 2: Insert the cable connector. Press the clip on the connector at the end of the
SATA cable and insert the cable connector into the on-board SATA drive
connector. See Figure 4-12.
Comentarios a estos manuales