Iei-integration HYPER-KBN Manual de usuario descargar pdf (Pagina 51)

HYPER-KBN

Page 39

4.4 Internal Peripheral Device Connections

This section outlines the installation of peripheral devices to the on-board connectors

4.4.1 Audio Kit Ins tallation

The Audio Kit that came with the HYPER-KBN connects to the audio connector on the

HYPER-KBN. The audio kit consists of three audio jacks. Mic-in connects to a microphone.

Line-in provides a stereo line-level input to connect to the output of an audio device.

Line-out, a stereo line-level output, connects to two amplified speakers. To install the

audio kit, please refer to the steps below:

Step 1: Locate the audio connector. The location of the 10-pin audio connector is

shown in Chapter 3.

Step 2: Align pin 1. Align pin 1 on the on-board connector with pin 1 on the audio kit

connector. Pin 1 on the audio kit connector is indicated with a white dot. See

Figure 4-2.

Figure 4-2: Audio Kit Cable Connection

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 138 139

Sin comentarios

Iei-integration HYPER-KBN Manual de usuario Pagina 51