Iei-integration ICE-945GSE v1.11 Manual de usuario descargar pdf (Pagina 54)

ICE-945GSE COM Express Type 2 Module

Page 42

5.4.2 BIOS Selection

Jumper Label: SW2

Jumper Type:

4-in-1 switch

Jumper Settings:

See

Table 5-3

Jumper Location:

See

Figure 5–2

This jumper selects which BIOS to use. There is a BIOS included on the ICE-945GSE, but

a BIOS connected to the LPC or PCI bus can be used instead. The clear CMOS jumper

settings are shown in

Table 5-3.

1 2 3 4 Description

OFF ON OFF OFF SPI

ON OFF OFF OFF LPC

OFF OFF OFF OFF PCI

Table 5-3: BIOS Selection

5.5 Mounting the ICE-945GSE

WARNING!

Never run the embedded module without the heat sink. The

heatspreader plate shipped with the ICE-945GSE acts as a thermal

interface between the module and the heat sink. The heat sink must be

installed on the heatspreader plate to maintain proper operating

temperatures. Make sure to maintain the heatspreader plate

temperature under 60°C in operation.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 146 147

Sin comentarios

Iei-integration ICE-945GSE v1.11 Manual de usuario Pagina 54