Iei-integration ICE-DB-T6 Manual de usuario descargar pdf (Pagina 58)

Type 6 Carrier Board Design Guide

Page 48

CMOS

A83 LVDS_I2C_CK O 3.3V

CMOS

DDC I2C clock signal used for flat panel detection

and control.

A84 LVDS_I2C_DAT I/O 3.3V

OD CMOS

DDC I2C data signal used for flat panel detection

and control.

Table 3-14: LVDS Signals Description

3.6.2 LVDS Cable Consideration

Balanced cables (twisted pair) are usually better than unbalanced cables (ribbon cable)

for noise reduction and signal quality. Balanced cables provide a low-cost solution with

good balance and flexibility. They tend to generate less EMI due to field canceling effects

and also tend to pick up electromagnetic radiation as common-mode noise, which is

rejected by the receiver. They are capable of medium to long runs.

Unbalanced cables are a cost effective and easy solution. They work fine for very short

runs even though they are not well suited for high-speed differential signaling. Most cables

will work effectively for cable distances of <0.5m.

3.6.3 Backlight and LCD Power Timing Control

Figure 3-19 and Figure 3-20 show the reference design of backlight and LCD power timing

control.

Figure 3-21 shows the LCD power sequence, and design must conform to its

power sequence. VIN represents LCD power and lamp represents LCD backlight power.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 128 129

Sin comentarios

Iei-integration ICE-DB-T6 Manual de usuario Pagina 58