Iei-integration IMB-C2060 v2.00 Manual de usuario descargar pdf (Pagina 74)

IMB-C2060 microATX Motherboard

Page 60

4.4 Internal Peripheral Device Connections

This section outlines the installation of peripheral devices to the onboard connectors.

4.4.1 SATA Drive Connection

The IMB-C2060 is shipped with four SATA drive cables. To connect the SATA drives to

the connectors, please follow the steps below.

Step 1: Locate the connectors. The locations of the SATA drive connectors are shown

in Chapter 3.

Step 2: Insert the cable connector. Insert the cable connector into the on-board SATA

drive connector. See

Figure 4-13.

Figure 4-13: SATA Drive Cable Connection

Step 3: Connect the cable to the SATA disk. Connect the connector on the other end

of the cable to the connector at the back of the SATA drive. See

Figure 4-14.

Step 4: Connect the SATA power cable (optional). Connect the SATA power

connector to the back of the SATA drive. See

Figure 4-14.

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 182 183

Sin comentarios

Iei-integration IMB-C2060 v2.00 Manual de usuario Pagina 74