Iei-integration IMB-Q670 v2.01 Manual de usuario descargar pdf (Pagina 69)

IMB-Q670 Micro-ATX Motherboard

Page 55

Step 4: Removing a DIMM. To remove a DIMM, push both handles outward. The

memory module is ejected by a mechanism in the socket.Step 0:

4.3 Jumper Settings

NOTE:

A jumper is a metal bridge used to close

an electrical circuit. It consists of two or

three metal pins and a small metal clip

(often protected by a plastic cover) that

slides over the pins to connect them. To

CLOSE/SHORT a jumper means

connecting the pins of the jumper with

the plastic clip and to OPEN a jumper means removing the plastic clip

from a jumper.

The hardware jumpers must be set before installation. Jumpers are shown in Table 4-1.

Description Label Type

AT/ATX Auto power setting jumper (by active hardware) JATX_AT1 2-pin header

Clear CMOS jumper J_CMOS2 3-pin header

ME Debug connector J_FLASH1 3-pin header

USB power select jumper USB_PWR1 3-pin header

Wake-on LAN WOL_SEL1 3-pin header

Table 4-1: Jumpers

4.3.1 AT/ATX Power Mode Jumper (by active hardware)

Jumper Label: JATX_AT1

Jumper Type:

2-pin header

Jumper Settings:

See Table 4-2

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 178 179

Sin comentarios

Iei-integration IMB-Q670 v2.01 Manual de usuario Pagina 69