Iei-integration IMBA-9454 v4.02 Manual de usuario descargar pdf (Pagina 103)

IMBA-9454G Motherboard

Page 85

cap to close pins 2 and 3 for a few seconds then reinstall the jumper clip back to pins 1

and 2.

If the “CMOS Settings Wrong” message is displayed during the boot up process, the fault

may be corrected by pressing the F1 to enter the CMOS Setup menu. Do one of the

following:

 Enter the correct CMOS setting

 Load Optimal Defaults

 Load Failsafe Defaults.

After having done one of the above, save the changes and exit the CMOS Setup menu.

The clear CMOS jumper settings are shown in Table 5-3.

Pins Description

Short 1 - 2 Keep CMOS Setup Default

Short 2 – 3 Clear CMOS Setup

Table 5-3: Clear CMOS Jumper Settings

Figure 5-10: Clear CMOS Jumper Location

5.4.3 COM2 Mode Selection

Jumper Label:

JP4

Jumper Type:

3-pin header

Jumper Settings:

See Table 5-4

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 204 205

Sin comentarios

Iei-integration IMBA-9454 v4.02 Manual de usuario Pagina 103