Iei-integration IMBA-Q454 v1.01 Manual de usuario Pagina 81

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 213
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 80
IMBA-Q454-R10 User Manual
Page 81
Step 1: Locate the connectors. The locations of the USB connectors are shown in
Chapter 4.
WARNING:
If the USB pins are not properly aligned, the USB device can burn out.
Step 2: Align the connectors. Each cable has two connectors. Correctly align pin 1on
each cable connector with pin 1 on the IMBA-Q454-R10 USB connectors.
Step 3: Insert the cable connectors. Once the cable connectors are properly aligned
with the USB connectors on the IMBA-Q454-R10, connect the cable connectors
to the on-board connectors. See
8Figure 4-14.
Figure 4-15: Four Port USB Cable Connection
Step 4: Attach the bracket to the chassis. The USB 2.0 connectors are attached to a
bracket. To secure the bracket to the chassis please refer to the installation
instructions that came with the chassis.Step 0:
Vista de pagina 80
1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 212 213

Comentarios a estos manuales

Sin comentarios