Iei-integration NANO-QM770 Manual de usuario descargar pdf (Pagina 70)

NANO-QM770 EPIC SBC

Page 55

Figure 4-13: SATA Drive Cable Connection

Step 3: Connect the cable to the SATA disk. Connect the connector on the other end

of the cable to the connector at the back of the SATA drive. See

Figure 4-13.

Step 4: To remove the SATA cable from the SATA connector, press the clip on the

connector at the end of the cable. Step 0:

4.7.4 Single RS-232 Cable (w/o Bracket)

The single RS-232 cable consists of one serial port connector attached to a serial

communications cable that is then attached to a D-sub 9 male connector. To install the

single RS-232 cable, please follow the steps below.

Step 1: Locate the connector. The location of the RS-232 connector is shown in

Chapter 3.

Step 2: Insert the cable connector. Insert the connector into the serial port pin header.

See

Figure 4-14. A key on the front of the cable connectors ensures the

connector can only be installed in one direction.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 189 190

Sin comentarios

Iei-integration NANO-QM770 Manual de usuario Pagina 70