Iei-integration DM_Series v2.04 Manual de usuario descargar pdf (Pagina 74)

DM Series Monitor

Page 60

Step 5: Tighten the screws that pass through the panel mounting clamps until the plastic

caps at the front of all the screws are firmly secured to the panel (

5Figure 5-15).

5.5.1.2 DM-65 Panel Mounting

To mount the DM-65 monitor into a panel, follow steps one through three of the standard

panel mounting procedure (Section

55.5.1.1), then continue using the steps below.

Step 1: Cut out a section of the panel that corresponds to the rear panel dimensions of

the monitor.

Figure 5-16: DM-65 Panel Opening (Unit: mm)

Step 2: Secure the panel mounting clips to either side of the monitor using the retention

screws supplied in the mounting kit pack (

5Figure 5-17).

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 127 128

Sin comentarios

Iei-integration DM_Series v2.04 Manual de usuario Pagina 74