Iei-integration AFL2-08A-N26 Manual de usuario descargar pdf (Pagina 39)

AFL2-08A-N26

Page 23

 Anti-static Discharge: If a user open the rear panel of the flat bezel panel PC,

to configure the jumpers or plug in added peripheral devices, ground

themselves first and wear and anti-static wristband.

4.3 Installation and Configuration Steps

The following installation steps must be followed.

Step 1: Unpack the flat bezel panel PC.

Step 2: Install the mSATA card.

Step 3: Configure the system.

Step 4: Connect peripheral devices to the flat bezel panel PC.

Step 5: Mount the flat bezel panel PC. Step 0:

4.4 mSATA card Installation

WARNING:

Over-tightening back

cover screws will crack the plastic frame.

Maximum torque for cover screws is 5 kg-cm (0.36 lb-ft/0.49 Nm).

To install the mSATA card into the AFL2-08A-N26, please follow the steps below:

Step 1: Remove one (1) retention screw from the mSATA cover (Figure 4-1).

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 194 195

Sin comentarios

Iei-integration AFL2-08A-N26 Manual de usuario Pagina 39