Iei-integration AFL2-08A-N26 Manual de usuario descargar pdf (Pagina 55)

AFL2-08A-N26

Page 39

Step 2: Insert the serial connector. Insert the DB-9 connector of a serial device into

the DB-9 connector on the bottom panel. See Figure 4-18.

Figure 4-18: DB-9 Serial Port Connector

Step 3: Secure the connector. Secure the serial device connector to the external

interface by tightening the two retention screws on either side of the connector.

Ste p 0:

4.12.4.2 RJ-11 Serial Port Connection

Follow the steps below to connect a serial device to the RJ-11 serial port connector of the

AFL2-08A-N26 panel PC.

Step 1: Locate the RJ-11 serial port. The location of the RJ-11 serial port is shown in

Chapter 1.

Step 2: Connect the RJ-11 to DB-9 COM port cable to the panel PC. Insert the RJ-11

connector end of cable into the RJ-11 serial port. See Figure 4-19.

Step 3: Connect the serial device. Connect a serial device to the DB-9 connector end

of the cable. See Figure 4-19.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 194 195

Sin comentarios

Iei-integration AFL2-08A-N26 Manual de usuario Pagina 55