Iei-integration AFL2-W15B-H61 Manual de usuario descargar pdf (Pagina 144)

Page 126

AFL2-W15B-H61

Step 1: Follow all anti-static procedures. See Section 7.2.

Step 2: Turn off the power. See Section

7.3.

Step 3: Remove the back cover. See Section

7.4.1 above.

Step 4: Remove the internal aluminum back cover. See Section

7.4.2 above.

Step 5: Locate the DDR3 SO-DIMM on the motherboard.

Step 6: Remove the DDR3 memory module by pulling both the spring retainer clips

outward from the socket.

Step 7: Grasp the DDR3 memory module by the edges and carefully pull it out of the

socket.

Step 8: Install the new DDR3 memory module by pushing it into the socket at an angle

(

Figure 7-4).

Step 9: Gently pull the spring retainer clips of the SO-DIMM socket out and push the

rear of the DDR memory module down (

Figure 7-4).

Step 10: Release the spring retainer clips on the SO-DIMM socket. They clip into place

and secure the DDR memory module in the socket.

Figure 7-4: DDR SO-DIMM Module Installation

Step 11: Replace the internal aluminum cover and secure it to the chassis using six (6)

retention screws.

1 2 ... 139 140 141 142 143 144 145 146 147 148 149 ... 218 219

Sin comentarios

Iei-integration AFL2-W15B-H61 Manual de usuario Pagina 144