Iei-integration AFL2-W15B-H61 Manual de usuario descargar pdf (Pagina 52)

Page 34

AFL2-W15B-H61

3.12.2 Panel Mounting

To mount the AFL2-W15B-H61 flat bezel panel PC into a panel, please follow the steps

below.

Step 1: Select the position on the panel to mount the flat bezel panel PC.

Step 2: Cut out a section corresponding to the size shown below. The size must be

smaller then the outer edge.

Figure 3-17: Cutout Dimensions

Step 3: Slide the flat bezel panel PC through the hole until the frame is flush against the

panel.

Step 4: Align the panel mounting bracket screw holes with the VESA mounting holes on

the rear of the panel PC.

Step 5: Secure the two panel mounting brackets to the rear of the panel PC by inserting

the four retention screws into the VESA mounting holes (

Figure 3-18

Step 6: Insert the panel mounting clamps into the holes of the panel mounting brackets

(

Figure 3-18

). There are a total of 4 panel mounting clamps for

AFL2-W15B-H61.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 218 219

Sin comentarios

Iei-integration AFL2-W15B-H61 Manual de usuario Pagina 52