Iei-integration EC-1040G Manual de usuario descargar pdf (Pagina 42)

EC-1040GB Workstation

Page 32

Figure 4-8: 3.5” to 5.25” Drive Bay Rack Retention Screws

Step 3: Remove the drive bracket from the EC-1040GB rackmount workstation (see

Section 4.5.3).

Step 4: Remove the 3.5” drive bracket from the 5.25” drive bracket (see Section 4.5.5).

Step 5: Install the 3.5” to 5.25” drive bay rack into the drive bracket (see Section 4.5.6)

Step 0:

4.5.6.3 3.5” Disk Drive

To install a 3.5” disk drive, follow the instructions below.

Step 1: Remove the drive bracket from the EC-1040GB rackmount workstation

(see Section 4.5.3).

Step 2: Remove the 3.5” drive slot blank plate (see Section 4.5.4).

Step 3: Slide a 3.5” disk drive into the 3.5” drive bracket. Make sure the IDE/SATA

connector and the power connectors of the drive are facing the rear of the drive

bracket.

Step 4: Insert the appropriate number of retention screws into each side of the 3.5” disk

drive through the 3.5” drive bracket (Figure 4-9).Step 0:

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 84 85

Sin comentarios

Iei-integration EC-1040G Manual de usuario Pagina 42