Iei-integration WAFER-945GSE2 v1.03 Manual de usuario descargar pdf (Pagina 96)

WAFER-945GSE2 User Manual

Page 79

Step 3: Insert the LAN cable RJ-45 connector. Once aligned, gently insert the LAN

cable RJ-45 connector into the onboard RJ-45 connector. Step 0:

5.7.2 Serial Device Connection

The WAFER-945GSE2 has a single female DB-9 connector on the external peripheral

interface panel for a serial device. Follow the steps below to connect a serial device to the

WAFER-945GSE2.

Step 1: Locate the DB-9 connector. The location of the DB-9 connector is shown in

Chapter 3.

Step 2: Insert the serial connector. Insert the DB-9 connector of a serial device into

the DB-9 connector on the external peripheral interface. See

8Figure 5-17.

Figure 5-17: Serial Device Connector

Step 3: Secure the connector. Secure the serial device connector to the external

interface by tightening the two retention screws on either side of the connector.

Step 0:

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 203 204

Sin comentarios

Iei-integration WAFER-945GSE2 v1.03 Manual de usuario Pagina 96