
WAFER-LX User Manual
The following notes show how to connect ATX Power Supply to the embedded board.
1. Using ATX Power Switch
Step 1. Disconnect the AC cord of the Power Supply from the AC source to prevent
sudden electric surge to the board.
Step 2. Properly configure the JP1 jumper. Remove the jumper cap from JP1 and
CN2.
Figure B-1 ATX Power Connection
WARNING!
The new power adapter cable for the WAFER-LX has its “Ground” pin
removed from the 3-pin ATX feature connector. If you connect the
power feature connector cable previously provided by IEI, you will
destroy the WAFER-LX board.
Step 3. Connect an ATX power button switch (see the diagram above) to the ATX
B-2
B-2
IEI
®
Technology, Corp.
Comentarios a estos manuales