Iei-integration WAFER-LX v1.22 Manual de usuario Pagina 134
- Pagina / 227
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
WAFER-LX Motherboard
Page 116
N/A (Default)
C800
CC00
D000
D400
D800
DC00
Î x Reserved Memory Length [8K]
The Reserved Memory Length option can only be accessed if the Reserved Memory
Base option is not set to N/A. The Reserved Memory Length specifies the amount of
memory reserved for the peripheral device. The Reserved Memory Length options:
8K (Default)
16K
32K
64K
Î PCI/VGA Palette Snoop [Disabled]
Use the PCI/VGA Palette Snoop option to enable the system to determine whether or not
some special VGA cards, high-end hardware MPEG decoders and other similar devices
are allowed to look at the VGA palette on the video card so these devices can determine
what colors are in use. This option is needed very rarely and should be left "Disabled"
unless a video device specifically requires the setting to be enabled upon installation.
Î
Disabled DEFAULT
Does not allow the graphics devices to examine the
VGA palette on the graphics card.
Î
Enabled
Allows the graphics devices to examine the VGA
palette on the graphics card.
- WAFER-LX 1
- Revision 2
- Copyright 3
- Packing List 4
- Table of Contents 5
- List of Figures 11
- List of Tables 15
- BIOS Menus 17
- 1 Introduction 19
- 1.1 Overview 20
- 2 Detailed Specifications 27
- 2.1 Overview 28
- 2.2 Dimensions 28
- Page 11 29
- 2.3 Data Flow 30
- 2.4 AMD Geode™ LX 800 CPU 31
- Page 14 32
- 2.6 Graphics Support 33
- 2.7 Memory Support 34
- 2.10 Drive Interfaces 36
- 2.11 Serial Ports 37
- 2.12 Real Time Clock 37
- 2.13 System Monitoring 37
- 2.14 USB Interfaces 37
- 2.15 BIOS 37
- Page 20 38
- 2.18 Power Consumption 39
- 3 Unpacking 41
- 3.1 Anti-static Precautions 42
- 3.2 Unpacking 42
- 3.3 Unpacking Checklist 43
- Page 26 44
- 4 Connectors and Jumpers 45
- Page 29 47
- Page 30 48
- NOTE: 49
- PIN NO. DESCRIPTION 50
- 1 +12 V 50
- 3 PS_ON 52
- 1 PWRBTN# 52
- Page 35 53
- 1 Battery+ 54
- 2 Ground 54
- Page 38 56
- 4.2.7 Fan Connector 56
- 1 CPUFAN_OUT 57
- 2 +12 V 57
- Page 40 58
- 1 GND 2 5 V 59
- 3 GPO0 4 GPO1 59
- 5 GPO2 6 GPO3 59
- 7 GPI0 8 GPI1 59
- 9 GPI2 10 GPI3 59
- Page 43 61
- 1 ADJ (Def: GND) 62
- 5 BL_EN 62
- 3 -12 V 66
- Page 49 67
- Page 50 68
- 1 Reset+ 69
- Page 54 72
- Page 56 74
- 1 VCC_USB 2 GND 75
- 3 DATA3- 4 DATA4+ 75
- 5 DATA3+ 6 DATA4 75
- 7 GND 8 VCC_USB 75
- 1 VCC_USB 5 VCC_USB 76
- 2 DATA1- 6 DATA2 76
- 3 DATA1+ 7 DATA2+ 76
- 4 GND 8 GND 76
- 1 TX+ 2 TX 77
- 3 RX+ 4 NC 77
- 5 NC 6 RX 77
- 7 NC 8 NC 77
- 1 RED 6 GROUND 11 NC 78
- 2 GREEN 7 GROUND 12 DDCDAT 78
- 3 BLUE 8 GROUND 13 HSYNC 78
- 4 NC 9 NC 14 VSYNC 78
- Page 61 79
- 5 Installation and 80
- Configuration 80
- 5.1 Anti-static Precautions 81
- 5.3 Unpacking 82
- WARNING! 83
- Page 70 88
- 2-3 IDE Master 91
- TFT LCD Type Description 91
- 1-2 FPCLK Default 91
- 2-3 #FPCLK 91
- 5.6 Chassis Installation 92
- 5.7 Rear Panel Connectors 92
- 6 BIOS Setup 94
- 6.1 Introduction 95
- Page 80 98
- 6.2 Standard CMOS Features 99
- WAFER-LX Motherboard 100
- Page 82 100
- 6.3 Advanced BIOS Features 103
- NTER and 108
- Page 93 111
- Page 94 112
- Page 97 115
- Page 98 116
- 6.5 Integrated Peripherals 117
- Page 102 120
- Page 107 125
- Page 108 126
- 6.6 Power Management Setup 127
- 6.7 PnP/PCI Configurations 129
- Page 114 132
- Page 115 133
- 6.8 PC Health Status 135
- Page 118 136
- 7 RAID Setup 137
- 7.1 VIA® RAID Utility 138
- 7.3 Creating a RAID Array 139
- Page 122 140
- 7.3.1 Automatic Setup 140
- Page 123 141
- Page 124 142
- 7.3.2 Manual Setup 142
- Page 125 143
- Page 126 144
- Page 127 145
- 7.4 Delete a RAID Array 146
- Page 129 147
- 7.5 Selecting a Boot Array 148
- Page 131 149
- Page 132 150
- 7.7 Exiting The RAID Utility 151
- 8 Software Drivers 152
- Page 136 154
- 8.2 Device Driver Menu 155
- Page 138 156
- Page 139 157
- 8.3 VGA Driver 158
- Page 141 159
- Page 142 160
- Page 143 161
- Page 144 162
- Page 145 163
- Page 146 164
- Page 147 165
- 8.4 Audio Driver 166
- Page 149 167
- Page 150 168
- Page 151 169
- Page 152 170
- Page 153 171
- Page 154 172
- Page 155 173
- Page 156 174
- 8.5 LAN Driver 175
- Page 158 176
- Page 159 177
- Page 160 178
- Page 161 179
- Page 162 180
- 8.6 SATA/RAID Driver 181
- Page 164 182
- Page 165 183
- Page 166 184
- Page 167 185
- 8.7 ISA Driver 186
- Page 169 187
- Page 170 188
- Page 171 189
- Page 172 190
- Page 173 191
- Page 174 192
- Page 175 193
- A BIOS Options 194
- B Terminology 198
- Page 181 199
- Page 182 200
- Page 183 201
- C Digital I/O Interface 202
- C.1 Introduction 203
- C.2 DIO Connector Pinouts 203
- D Watchdog Timer 205
- Page 188 206
- E Address Mapping 208
- E.1 IO Address Map 209
- Extend BIOS 210
- E.4 DMA Channel Assignments 211
- F Compatibility 212
- F.2 Compatible Processors 213
- Page 196 214
- G Hazardous Materials 215
- Disclosure 215
- Mercury 216
- Page 199 217
- Page 200 218
- H RAID Levels 219
- H.1 RAID 0 221
- H.2 RAID 1 222
- H.3 JBOD 223
- Page 206 224
Relacionado con productos y manuales para Hardware Iei-integration WAFER-LX v1.22
Hardware Iei-integration LVDS24-01 Manual de usuario
(10 paginas)
(10 paginas)
Dual-electronics XPA4640 manuály
Uživatelské manuály a uživatelské příručky pro Zesilovač do auta Dual-electronics XPA4640.
Poskytujeme 1 manuály pdf Dual-electronics XPA4640 ke stažení zdarma podle typů dokumentů: Uživatelský manuál
Comentarios a estos manuales