Iei-integration UPC-12A_GM45 v2.10 Manual de usuario descargar pdf (Pagina 51)

UPC-12A/GM45 Panel PC

Page 39

Step 3: Insert a PCI card into the PCI slot (543H543H543H543H543H543H543H545HFigure 4-8).

Step 4: Secure the PCI card with the retention screw (

544H544H544H544H544H544H544H546HFigure 4-8).

Step 5: Replace the back cover. Step 0:

4.9 Jumper Settings

NOTE:

A jumper is a metal bridge used to close an

electrical circuit. It consists of two or three metal

pins and a small metal clip (often protected by a

plastic cover) that slides over the pins to connect

them. To CLOSE/SHORT a jumper means

connecting the pins of the jumper with the plastic

clip and to OPEN a jumper means removing the

plastic clip from a jumper.

Figure 4-9: Jumper Locations

The following jumpers can be found on the motherboard installed in the UPC-12A/GM45.

Before the UPC-12A/GM45 is installed, the jumpers must be set in accordance with the

desired configuration. The jumpers on the UPC-12A/GM45 motherboard are listed in

545H545H545H545H545H545H545H547HTable 4-1.

Description Label Type

CF card setup JP8 2-pin header

CF voltage select JP7 3-pin header

JP4 14-pin header COM4 function select

JP5 12-pin header

Table 4-1: Jumpers

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 144 145

Sin comentarios

Iei-integration UPC-12A_GM45 v2.10 Manual de usuario Pagina 51