Iei-integration UPC-12A_GM45 v2.10 Manual de usuario descargar pdf (Pagina 62)

UPC-12A/GM45 Panel PC

Page 50

Step 5: Tighten the screws that pass through the panel mounting clamps until the plastic

caps at the front of all the screws are firmly secured to the panel (

566H566H566H566H566H566H566H568HFigure 4-19).

Figure 4-19: Tighten the Panel Mounting Clamp Screws

4.10.3 Arm Mounting

The flat panel PC is VESA (Video Electronics Standards Association) compliant and can

be mounted on an arm with a 100 mm interface pad. To mount the flat panel PC on an arm,

please follow the steps below.

Step 1: The arm is a separately purchased item. Please correctly mount the arm onto

the surface it uses as a base. To do this, refer to the installation documentation

that came with the mounting arm.

NOTE:

When purchasing the arm please ensure that it is VESA compliant and

that the arm has a 100 mm interface pad. If the mounting arm is not

VESA compliant it cannot be used to support the flat panel PC.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 144 145

Sin comentarios

Iei-integration UPC-12A_GM45 v2.10 Manual de usuario Pagina 62