Iei-integration IMBA-C2160 Manual de usuario descargar pdf (Pagina 74)

IMBA-C2160 ATX Motherboard

Page 58

Step 3: Insert the DIMM. Once aligned, press down until the DIMM is properly seated.

Clip the two handles into place. See

Figure 4-6.

Step 4: Removing a DIMM. To remove a DIMM, push both handles outward. The

memory module is ejected by a mechanism in the socket.Step 0:

4.3 Jumper Settings

NOTE:

A jumper is a metal bridge used to close

an electrical circuit. It consists of two or

three metal pins and a small metal clip

(often protected by a plastic cover) that

slides over the pins to connect them. To

CLOSE/SHORT a jumper means

connecting the pins of the jumper with

the plastic clip and to OPEN a jumper means removing the plastic clip

from a jumper.

The hardware jumpers must be set before installation. Jumpers are shown in Table 4-1.

Description Label Type

AT/ATX power select JATX_AT1 2-pin header

Clear CMOS jumper J_CMOS1 3-pin header

Flash descriptor security override J_FLASH1 3-pin header

USB power select jumpers K/M_USB1_PWR1,

CNUSB1_PWR1,

USB_PWR1,

USB_PWR2,

USB_PWR3

3-pin header

Wake-on LAN WOL_SEL1 3-pin header

Table 4-1: Jumpers

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 216 217

Sin comentarios

Iei-integration IMBA-C2160 Manual de usuario Pagina 74