Iei-integration NANO-LX v1.10 Manual de usuario descargar pdf (Pagina 106)

NANO-LX EPIC SBC

5.8.5 Single RS-232 Cable

The single RS-232 cable consists of one serial port connectors attached to a serial

communications cable that is then attached to a D-sub 9 male connector. To install the

single RS-232 cable, please follow the steps below.

Step 1: Locate the connector. The location of the RS-232 connector is shown in

Chapter 3.

Step 2: Insert the cable connector. Insert the connector into the serial port box header.

See

Figure 5-10. A key on the front of the cable connectors ensures the

connector can only be installed in one direction.

Figure 5-10: Single RS-232 Cable Installation

5.8.6 SATA Drive Connection

The NANO-LX is shipped with two SATA drive cables and one SATA drive power cable.

To connect the SATA drives to the connectors, please follow the steps below.

Step 3: Locate the connectors. The locations of the SATA drive connectors are shown

in Chapter 3.

Step 4: Insert the cable connector. Press the clip on the connector at the end of the

Page 106

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 231 232

Sin comentarios

Iei-integration NANO-LX v1.10 Manual de usuario Pagina 106