Iei-integration NANO-LX v1.21 Manual de usuario descargar pdf (Pagina 89)

NANO-LX EPIC SBC

Page 74

5.6 Jumper Settings

NOTE:

A jumper is a metal bridge used to close an

electrical circuit. It consists of two or three metal

pins and a small metal clip (often protected by a

plastic cover) that slides over the pins to connect

them. To CLOSE/SHORT a jumper means

connecting the pins of the jumper with the plastic

clip and to OPEN a jumper means removing the

plastic clip from a jumper.

Figure 5-3: Jumper Locations

Before the NANO-LX is installed in the system, the jumpers must be set in accordance

with the desired configuration. The jumpers on the NANO-LX are listed in

Table 5-1.

Description Label Type

AT/ATX Power Mode Select 2-pin header JP4

CF mode select 3-pin header JP8

COM1, COM2 RI Pin and Voltage Selection (Optional) 10-pin header JP2

COM3 RS422/RS485 Select 3-pin header JP3

LCD Panel (LVDS/TTL) Voltage select 2-pin header JP7

LCD PANEL SHIFT CLOCK 3-pin header JP1

PC104 Plus VIO Voltage Select 3-pin header JP5

SERIRQ Select 2-pin header JP6

Table 5-1: Jumpers

NOTE:

The NANO-LX does not provide a “Clear CMOS” configuration jumper. If the

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 191 192

Sin comentarios

Iei-integration NANO-LX v1.21 Manual de usuario Pagina 89