Iei-integration NOVA-945GSE v1.01 Manual de usuario descargar pdf (Pagina 90)

NOVA-945GSE 5.25” SBC

Page 90

Step 2: Align the SO-DIMM with the socket. The SO-DIMM must be oriented in such a

way that the notch in the middle of the SO-DIMM must be aligned with the

plastic bridge in the socket.

Step 3: Insert the SO-DIMM. Push the SO-DIMM chip into the socket at an angle. (See

777HFigure 5-1)

Step 4: Open the SO-DIMM socket arms. Gently pull the arms of the SO-DIMM socket

out and push the rear of the SO-DIMM down. (See

778HFigure 5-1)

Step 5: Secure the SO-DIMM. Release the arms on the SO-DIMM socket. They clip into

place and secure the SO-DIMM in the socket.Step 0:

5.4.2 CF Card Installation

NOTE:

The NOVA-945GSE can support both CF Type I cards and CF Type II

cards. For the complete specifications of the supported CF cards

please refer to Chapter 2.

To install the a CF card (Type I or Type II) onto the NOVA-945GSE, please follow the

steps below:

Step 1: Locate the CF card socket. Place the NOVA-945GSE on an anti-static pad with

the solder side facing up. Locate the CF card.

Step 2: Align the CF card. Make sure the CF card is properly aligned with the CF

socket.

Step 3: Insert the CF card. Gently insert the CF card into the socket making sure the

socket pins are properly inserted into the socket. See

779HFigure 5-2. Step 0:

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 194 195

Sin comentarios

Iei-integration NOVA-945GSE v1.01 Manual de usuario Pagina 90