Iei-integration NOVA-PV-D4251_D5251 v1.01 Manual de usuario Pagina 81

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 179
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 80
NOVA-PV-D5251/D4251 5.25" SBC
Page 67
4.5 Jumper Settings
NOTE:
A jumper is a metal bridge used to close an
electrical circuit. It consists of two or three metal
pins and a small metal clip (often protected by a
plastic cover) that slides over the pins to connect
them. To CLOSE/SHORT a jumper means
connecting the pins of the jumper with the plastic
clip and to OPEN a jumper means removing the
plastic clip from a jumper.
Figure 4-3: Jumper Locations
Before the NOVA-PV-D5251/D4251 is installed in the system, the jumpers must be set in
accordance with the desired configuration. The jumpers on the NOVA-PV-D5251/D4251
are listed in
7Table 4-1.
Description Type Label
AT/ATX power mode setting 3-pin header J_AUTOPWR1
Clear CMOS 3-pin header J_CMOS1
COM6 RS-232/422/485 select 8-pin header JP5
CompactFlash® setup 2-pin header JCF1
CPU fan setting 3-pin header JP7
LVDS2 LCD voltage select 3-pin header J_VLVDS1
LVDS3 LCD voltage select 3-pin header J_VLVDS2
LVDS2 panel resolution select 8-pin header J_LCD_TYPE1
LVDS3 panel resolution select 6-pin header JP10
PCI-104 and VIO voltage select 3-pin header JP6
Table 4-1: Jumpers
Vista de pagina 80
1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 178 179

Comentarios a estos manuales

Sin comentarios