Iei-integration NOVA-PV-D4251_D5251 v1.01 Manual de usuario descargar pdf (Pagina 83)

NOVA-PV-D5251/D4251 5.25" SBC

Page 69

4.5.2 Clear CMOS

Jumper Label:

J_CMOS1

Jumper Type:

3-pin header (1x3)

Jumper Settings:

See

7Table 4-3

Jumper Location:

See

7Figure 4-5

If the NOVA-PV-D5251/D4251 fails to boot due to improper BIOS settings, the clear

CMOS jumper clears the CMOS data and resets the system BIOS information. To do this,

use the jumper cap to close pins 2 and 3 for a few seconds then reinstall the jumper clip

back to pins 1 and 2.

If the “CMOS Settings Wrong” message is displayed during the boot up process, the fault

may be corrected by pressing the F1 to enter the CMOS Setup menu. Do one of the

following:

 Enter the correct CMOS setting

 Load Optimal Defaults

 Load Failsafe Defaults.

After having done one of the above, save the changes and exit the CMOS Setup menu.

The clear CMOS jumper settings are shown in

7Table 4-3.

Setting Description

Short 1 - 2 Keep CMOS Setup (Default)

Short 2 - 3 Clear CMOS Setup

Table 4-3: Clear CMOS Jumper Settings

The location of the clear CMOS jumper is shown in 7Figure 4-5 below.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 178 179

Sin comentarios

Iei-integration NOVA-PV-D4251_D5251 v1.01 Manual de usuario Pagina 83