Iei-integration PM-LX2-800 Manual de usuario descargar pdf (Pagina 55)

PM-LX2-800 User Manual

Page 55

4.4.1 SO-DIMM Module Installation

The PM-LX2-800 motherboard has one 200-pin DDR SO-DIMM socket. To install the

DDR SO-DIMM module, follow the instructions below.

Step 1: Turn the PM-LX2-800 over so that the SO-DIMM socket is facing up.

Step 2: Push the SO-DIMM chip into the socket at an angle. (See

Figure 4-1)

Step 3: Gently pull the arms of the SO-DIMM socket out and push the rear of the

SO-DIMM module down. (See

Figure 4-1)

Step 4: Release the arms of the SO-DIMM socket. They clip into place and secure the

SO-DIMM module in the socket.

Figure 4-1: SO-DIMM Module Installation

The SO-DIMM is a critical component of the PM-LX2-800 and cannot be run if it is not

installed.

4.5 CompactFlash® Card Installation

A CompactFlash® Type 2 (CF Type II) card slot is located on the solder side of the CPU

board. When appropriately formatted, a CF Type II card can serve as a bootable hard

drive in applications where installation space is limited. The CF Type II card occupies a

secondary IDE channel. Configuration options can be found through the BIOS

configuration utility.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 122 123

Sin comentarios

Iei-integration PM-LX2-800 Manual de usuario Pagina 55