Iei-integration PM-LX2-800 Manual de usuario descargar pdf (Pagina 64)

PM-LX2-800 User Manual

Page 64

4.8.4 Single RS-232 Cable (without Bracket)

The single RS-232 cable consists of one serial port connector attached to a serial

communications cable that is then attached to a D-sub 9 male connector. To install the

single RS-232 cable, please follow the steps below.

Step 1: Locate the connector. The location of the RS-232 connector is shown in

Section

3.1.1.

Step 2: Insert the cable connector. Insert the connector into the serial port box header.

See

Figure 4-8. A key on the front of the cable connectors ensures the

connector can only be installed in one direction.

Figure 4-8: Single RS-232 Cable Installation

Step 3: Secure the bracket. The single RS-232 connector has two retention screws

that must be secured to a chassis or bracket.

Step 4: Connect the serial device. Once the single RS-232 connector is connected to

a chassis or bracket, connect a serial communications device to the chassis or

bracket.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 122 123

Sin comentarios

Iei-integration PM-LX2-800 Manual de usuario Pagina 64